Nonionic mineral oil defoamer HY-2289

Overview:

This product is a broad-spectrum and efficient mineral oil defoamer with fast defoaming speed and strong durability, which can be widely used in various water-based systems and has excellent cost performance. At the same time, the temperature and PH value are widely applicable, easy to operate and easy to disperse..

Physical indicators:

Appearance: Opaque off-white liquid

Solid content (%) : ≥ 98%

Stability (3000 RPM /20 min) : No stratification

Viscosity (25 ° C) : 300CS-500CS

Chemical properties:

HY-2289 is easy to use and can be added at any stage in the production process, with a typical dosage of 0.05%~0.2%. In the process of product preparation, it is usually recommended to add it in two stages, that is, adding half of the amount in the high-speed grinding and dispersion stage to inhibit the formation of foam, and stirring the remaining half in the later stage to obtain excellent defoaming effect. The optimal dosage depends on the site conditions.

Product features:

Broad-spectrum high efficiency, rapid foam breaking, good compatibility, excellent formula adaptability, wide PH adaptation range.

Application Recommendations:

Can be added as original or pre-diluent, and pre-dilution with the recommended solvent simplifies addition and mixing. Addition amount: about 0.5%, different formulas need to be experimented to determine the specific addition amount. There may be a little layering when left for a long time, and it can be shaken slightly before use without affecting the performance of the product.

Storage package:

Packaging: This product is packaged in original 25/200KG barrels (can be split);

Storage: Store in a cool and sheltered place, sealed and stored;

Transportation: This product should be well sealed during transportation to prevent moisture, strong alkalis, acids, and rainwater from entering.

Additional Disclaimer: This information is based on the information and experience currently available to us. It only describes the performance of our products, but does not guarantee the performance of the products in a legal sense. It is recommended to test our products first to determine if they can achieve the desired results.